Hello,
Connection with V235 is OK. Any difference with V234 ?

Same for me on remote computer. I can connect using simconnect method only with 232.

Yes I did.

Hello,
Build 233 on my remote PC doesn't connect to MSFS :

20:24:25.1 Initiating SimConnect FSX/MSFS SP2 connection.
20:24:25.2 SIMCONNECT_RECV_OPEN
20:24:25.2 SimconnectOnRecvOpen Connected to P3D/FSX
20:24:25.2 Connected to sim
20:24:25.3 Disconnecting from SimConnect
20:24:25.4 Disconnected from sim
20:24:28.1 Cleanup
20:25:12.0

I go back to build 232 and it's OK.

Hello Tim,
Good news, V4 build 228 makes the job, nore more problem of connection with the same configuration.
Merci.

Same results for me with this version.

So the problem is :

Why Plan-G V3, in remote mode, runs correctly with MSFS2020 and  not Plan-G V4 with the same computers and configuration ?

OK the connection is correct between the same remote computer (WIN7) and MSFS2020 (WIN10) using my old planG V3.1.4.129.
I use the same port 4506 and the protocol IPV4.
Is it possible to use that in V4.

The remote computer is under WIN7 and MSFS2020 is under WIN10 and I think that the problem is here. I have a full communication between this  two computer and I can build the Data base but I think that the communication via IP address doesn't work between WIN7 and WIN10.

This is the 64 bit version in remote mode but it's the same with 32 bit version.

Always the same problem with v221:

12:02:25.5 Initiating SimConnect FSX connection.
12:02:26.5 SetFSConnected: System.BadImageFormatException: Could not load file or assembly 'Microsoft.FlightSimulator.SimConnect, Version=11.0.62651.3, Culture=neutral, PublicKeyToken=baf445ffb3a06b5c'. Tentative de chargement d'un programme de format incorrect.
File name: 'Microsoft.FlightSimulator.SimConnect, Version=11.0.62651.3, Culture=neutral, PublicKeyToken=baf445ffb3a06b5c'
   at Plan_G.Model.SimConnect_FSX.Connect(IntPtr myWindow)
   at Plan_G.ViewModel.MainViewModel.SetFSConnected(Boolean value) in C:\Users\Tim\source\repos\Plan-G\ViewModel\MainViewModel.cs:line 5421

Then I don't understand the Config Index in SimConnect Settings, the value default is 0. Is it a good value ?

Same problem for me with PlanG V4 on a different computer. Data base construction OK but connection to MFSF NOK.

9:54:30.4 SetFSConnected: System.BadImageFormatException: Could not load file or assembly 'Microsoft.FlightSimulator.SimConnect, Version=11.0.62651.3, Culture=neutral, PublicKeyToken=baf445ffb3a06b5c'. Tentative de chargement d'un programme de format incorrect.
File name: 'Microsoft.FlightSimulator.SimConnect, Version=11.0.62651.3, Culture=neutral, PublicKeyToken=baf445ffb3a06b5c'
   at Plan_G.Model.SimConnect_FSX.Disconnect()
   at Plan_G.ViewModel.MainViewModel.SetFSConnected(Boolean value) in C:\Users\Tim\source\repos\Plan-G\ViewModel\MainViewModel.cs:line 5448