Well Tim, thanks for the suggestion but I only fly on IVAO and Plan-G does not show them.

I don't like comparing your tool with others in your forum but the recent new tool does show all 4 Network participants (including it's own) on it's map at the same time so I do exactly that and disable IVAO to avoid seeing my flight duplicated.

There must be something Plan-G does not like in my laptop that blocks a simple icon showing on my screen! :)

Thanks anyways and take care.

Well, thanks anyway Birdy.dma.
If you think of anything else, I'd be glad to present you with any further details :) I guess I am the only one who cannot see his a/c on the screen while I can even see online Vatsim pilots - flying or on ground.
Cheers.

Here are the required files in zip form after another trial with XP11.

One thing I was not sure was whether I was supposed to use "your" copies (which I did not) or were they sent to show the files you requested.

Regards.

Hi Birdy.dma,

Downloaded the tool, ran it which led me to believe it found 2 errors and fixed them, tried Plan-G immediately to no avail, switched the system off, re-started to see if it helped but still no movement :)
I am open to further suggestions to try to make this tool work in my laptop.
Another moving chart tool which I installed just recently detected the sim immediately at first try, showed my aircraft at it's current position and followed it thru a 4 hour flight this morning between Japan and Taiwan.
There must be something blocking/holding Plan-G to reach my sim data!
Regards.

No movement with the new version as well :(

Thanks birdy.dma, I will try it tonight.

I tried after changing the system locale but to no avail.

By the way, there is another similar tool which a fellow simmer recommended couple of days ago which works fine and shows my initial location, follows my aircraft on the map after entering the required IP# (in this case it is 127.0.0.1 and not my actual LAN assigned one) so I guess the problem is not with my setup but may be with the XPUIPC version I am using (XPUIPC Version 2.0.3.1 - copied from the ini file). I wouldn't mind trying a different/newer version to solve the problem if anyone can lead the way to it as I cannot locate any other - this one being the third.

Best regards.

I am having exactly the same problem with X-Plane 11 and XPUIPC! The common denominator here is Win 10 I guess. Could Language settings have an effect on Plan-G?

I already had tried that as well but will try again with the new installation shortly. Thanks for all your help, much appreciated.

Although I am sure I read somewhere in this forum that it did not matter where you install the tool, I tried what you advised to no avail :(

With 127.0.0.1, I lost Vatsim planes as well. When I entered my IP (192.168.1.26), I started seeing them but still no luck with my own :).

Well, my bad luck! Until a solution is found, keep smiling :)
Thanks for all the help.
Regards.

Finally downloaded after 4 attempts :) Will test and revert. Thanks.

That is exactly what I had downloaded yesterday. The win.xpl file is date stamped 10.02.2013 17:42 - same as what I have.

Last 2 screen shots.

I changed the IP# in the XPUIPC.ini file to 127.0.0.1

Ran both as Admin. Had NIC error pop-up during start-up of XP11.
Changed the IP# of FS Connections and still no Aircraft icon on map

Both are installed on the same laptop, same hard disk different folders:
Plan G folder is D:\Win10\Plan-G v3.1.4
X-Plane 11 folder is D:\X-Plane 11
Rgds.